FLOOR PAN part 4

[ 1 ]  [ 2 ]   [ 3 ]  [ 4 ]

HOME

I want to apologize for the long lapse between now and the last pics I put up. I didn't intend on taking the summer off but I did.



In this section I'm going to pull out this floor support brace and clean out 
the rust underneath of it and then put it back in. Because of the time it takes
to take all the pictures, resize, and put them on the computer, and put them on 
the website, I will be doing it in two sections.
The top sign says "take out the floor support brace". The brace is just to the right of that sign.

A couple of reasons why I'm doing this; I wanted to show a good picture of the spot welds, every once in a while on the forum the question comes up "what does a spot weld look like", the other reason is I wanted to show you the supports I'm putting in before I pull out the support that's in there.

Some people will think this is over-kill, maybe it is. But I'm a firm believer in keeping everything braced so nothing moves, especially on a rotisserie, and the other reason is if you put these floors and braces in without any stress, it may help when you go to align the doors, etc.



I only showed 4 arrows, but there are two more spot welds in there, I'll show them in another picture.



This is inside the car looking at the floor.




These are the two supports I'm going to spot weld in to keep anything from moving when I pull the other one out.



[ 1 ]  [ 2 ]   [ 3 ]  [ 4 ]

HOME