REAR SEAT BRACKET

[ 1 ]  [ 2 ]  HOME


When I took these measurements originally I used string lines with marks on the firewall to the back seat area, but I thought it would be easier to get the measurements for these pictures doing it this way. All of these are for the driver's side back seat floor bracket. At the end of the pictures I'll give you the passenger's side measurements.

This shows you what edge of the bracket I am using to get measurements from.

This also shows you what edge of the bracket I am getting measurements from.

The flat part of the body panel that my tape measure is sticking up against is about 1-1/4" to 1-1/2" up from the bottom of the floor. I have a small magnet holding the tape measure to the body, so the tape measure is horizontal right where it's at.

Like I mentioned before, the tape measure is horizontal and it's also ninety degrees off the inside of the body, so the tape measure is squared up and level in all of these measurements. The flat on the side panel of the body starts about 1-1/4" to 1-1/2" up like I mentioned before and the tape measure is right on the flat.

[ 1 ]  [ 2 ]  HOME